液压缸非线性弹簧力约束下轧机吸振器参数的优化

考虑四辊轧机液压缸非线性弹簧力约束的因素,引入吸振器控制装置,建立带有轧机吸振器的轧机辊系振动动力学模型;通过对轧机吸振器基本参数的优化,得出吸振器最优的阻尼系数和刚度系数;仿真分析不同质量、弹簧力、摩擦力对轧机辊系振动幅频特性曲线的影响规律,得到轧机吸振器的最优质量可以有效提高系统稳定性,轧机吸振器的最优弹簧力可以缩小系统的不稳定区域,轧机吸振器的最优摩擦力可以有效降低幅频特性曲线的高度,为有效抑制轧机辊系垂直振动提供理论支持。     

一种基于压缩感知的运动目标检测技术

运动目标检测是计算机视觉、图像处理等相关领域的研究热点，其核心就是对视频图像中的每一帧图像进行相应的研究和处理。本文主要研究思路是从压缩感知技术采样信号的角度出发，将每一帧的二维图像压缩采样成具有少量信息的一维信号，再通过信号重构用少量数据量将图像重构出来，最后通过目标检测技术对每一帧的图像进行运动目标提取。仿真实验表明该方法是可行和有效的，同时可以大大减少目标检测中所记录的数据量，解决海量数据的存储与传输问题。     

煤与高岭石表面性质对凝聚过程的影响机制

煤泥水中含大量高岭石等黏土矿物，为其絮凝沉降带来较大的困难。为明确矿物性质对凝聚过程的影响机制，在应用扩展的DLVO理论计算煤和高岭石颗粒间作用力的基础上，采用聚焦光束反射测量仪监测了CaCl2用量为4.50 mmol/L时20 g/L的煤和高岭石的悬浮液在60, 100和150 r/min的搅拌转速下的凝聚过程。结果表明，颗粒间的静电作用力在颗粒表面间距2?200 nm范围内起主导作用，高岭石的电负性较大，在凝聚过程中更难发生靠近和碰撞；较高的转速可为颗粒提供较大的动量，有利于提高碰撞频率，缩短完成凝聚所需时间，实验条件下，煤和高岭石的凝聚时间分别由74和123 s缩短至47和89 s。疏水性作用力在颗粒表面间距小于2 nm的范围内起主导作用，决定了颗粒的黏附效率；煤因强疏水性，在碰撞后更易黏附，且能抵抗更高的流体剪切作用，可由19.32 μm凝聚形成100 μm的大凝聚体，而高岭石则因其亲水性难以得到较大粒度的凝聚体，均小于30 μm。     

A system for time-fluctuating flow rate measurements in a single-blade pump circuit

Commonly used flow rate measurement systems provide an accurate and stable output value of the quasi-stationary flow rate. In some pump types as e.g. single-blade pumps significant flow rate fluctuations may occur even in steady operation points due to rotor-stator interaction. For the analysis of the time-resolved flow rate a new measurement and evaluation method is presented based on an electromagnetic flow meter. Internal averaging of the flow meter is deactivated and the raw signal is evaluated directly with a sampling rate of 3 kHz. With ensemble-averaging in combination with an impeller position detection, interfering signals acting on the time-resolved measurement signal are filtered out. Accompanying numerical simulations of the pump flow circuit are carried out with a 1D method of characteristics and validated against well-established time-resolved pressure measurements of the pump flow. Experiment and simulation show a resembling trend of pressure as well as flow rate fluctuations over the entire operation range of the pump. Thus, by the combined utilisation of measurement and simulation technique, we assure the validity of the ensemble-averaged flow rate fluctuation results. We find that the flow rate fluctuations show a consistent phase shift to the pressure fluctuations that increases towards overload. The flow rate amplitude is an order of magnitude smaller than the amplitude of the pressure fluctuations.     

Application of the sampling moiré method to shallow open-channel flows with circular roughness elements

This research presents an application of the sampling moiré method, a novel technique originally developed for measuring slight deformation of a static object such as a plate, to fluctuating free water surface in rough open channel flows. The method was used to capture the two-dimensional water surface deformation at a high sampling rate by dyeing the color of water white. The target flow was a very shallow subcritical flow with a depth of 1.5 times the height of the roughness. As a result, a series of instantaneous water surface profiles with non-uniform rough planes were successfully measured at a sampling rate of 100 Hz.It has become clear that the effect of dispersive gravity waves traveling on the water surface is greater than that of non-dispersive waves driven by the turbulence, and that this feature becomes more pronounced as the Froude number increases in such shallow flow conditions. Furthermore, it was experimentally and theoretically verified that the intensity of water surface fluctuation increases with the square of the Froude number. The decomposition of surface fluctuations due to gravity waves and subsurface turbulence using the wavenumber frequency spectrum revealed that the effects of subsurface turbulence are about 20%. This is much less than the contribution from gravity waves in very shallow flows as in this experiment.     

螺纹量规的数字化检测方法

螺纹量规是判定螺纹紧固件合格与否的重要量具,其几何参数的精确测量具有重要意义。利用螺纹综合测量仪完成了螺纹量规的数字化测量试验,分析得出该方法的测量结果准确,精度可靠。同时对螺纹综合测量仪测量中径的不确定度进行了评定,为螺纹量规的测量质量提供了参考依据。     

数字化核电厂班组SSA测度方法与实验研究

情景意识(SA)问题在数字化核电厂中更为突出。为识别班组共享情景意识（SSA）水平及行为形成因子（PSF）对班组SSA的影响，基于情景意识全面评估技术（SAGAT）建立一种班组SSA测量和计算方法并进行模拟机实验。结果表明，个体SA（ISA）水平与SSA水平有关，ISA级别越高，SSA级别越高；ISA和班组SSA都受到PSF的影响，PSF的状态水平越高，ISA和SSA的水平越高；对于不同的实验场景，操纵员的ISA水平和班组SSA水平不同，这表明风险场景的症状越明显及知识经验水平越好，ISA和SSA水平就越高。最后，通过被试的自评价识别当前PSF的状态水平，主要不良的PSF是班组沟通和合作水平、压力水平、人-机界面等。这些评估结果为提高数字化核电厂人因可靠性和安全水平提供了理论支持。     

面向长距离量子通信的双光子关联成像技术

量子时域鬼成像利用光子对的时间-频率关联性实现了50km光纤链路上的图像传送,有望应用于量子通信的协议中。然而,现有方案的成像质量较差,成像速度较慢,因此其应用性在一定程度上受到了限制。文章对已有成像方案进行了较大的改进,利用可编程滤波器数字设定待成像信息,进而实现了二维图像信息的自动化实时传送。实验结果证明,改进方案的成像质量和速度均有显著改善,有利于推动量子关联成像在量子通信领域的应用。     

基于CORS系统下GPS测量技术在地质测绘中的应用

GPS测量技术在测绘领域中的应用价值相当突出,有着不可替代的作用和地位。同时,基于CORS系统下GPS测量技术因为具备精准定位、高效率定位等特点,在行业当中被许多人士认可。对此,为了更好的提高GPS测量技术的应用价值,详细分析基于CORS系统下GPS测量技术,希望可以今后相关工作者提供理论性帮助。